Bronkhorst Multibus Manual do Utilizador Página 42
- Página / 50
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
BRONKHORST®
Page 42 Operational instructions for digital multibus instruments 9.17.023
11.2 LED’S INDICATIONS
11.2.1 LED indications mode (no switch used)
Led
Time
Indication
Green
off
Continuous
Power-off or program not running
on
Continuous
Normal running/operation mode
Short
flash
0.1 sec on
2.0 sec off
Initialization mode (Init reset = 73)
For MBC3 type: no bus communication, safe state active.
normal
flash
0.2 sec on
0.2 sec off
Special function mode
Instrument is busy performing any special function. E.g. auto-zero or self-test
long flash
2.0 sec on
0.1 sec off
Special mode, see specific field bus for more details
FLOW-BUS
Not used
PROFIBUS-DP /Modbus
Not used
DeviceNet (MBC-II)
Idle state
DeviceNet (MBC3)
See special table below
EtherCAT
Not used
Red
off
Continuous
No error
Short
flash
0.1 sec on
2.0 sec off
Special mode, see specific field bus for more details
FLOW-BUS
Node occupied: Re-install instrument
PROFIBUS-DP
No data-exchange between master and slave Automatic recovery
Modbus
Data is received or transmitted
DeviceNet (MBC-II)
Minor communication error
DeviceNet (MBC3)
See special table below
EtherCAT
Instrument is not in OP mode (see EtherCAT manual for details)
normal
flash
0.2 sec on
0.2 sec off
Warning message.
An error occurred of minor importance.
It would be wise to investigate the cause of this.
You are still able to work with your instrument.
See specific field bus for more details
FLOW-BUS
Waiting for communication
PROFIBUS-DP / Modbus
No details
DeviceNet (MBC-II)
No bus power
DeviceNet (MBC3)
See special table below
EtherCAT
Not used
long flash
2.0 sec on
0.1 sec off
See specific field bus for more details
FLOW-BUS
Not used
PROFIBUS-DP
A requested parameter is not available.
See troubleshoot in Profibus manual.
Modbus
For special service purpose only
DeviceNet (MBC-II)
Serious communication error; manual intervention needed
DeviceNet (MBC3)
See special table below
EtherCAT
Error detected in EtherCAT configuration (see EtherCAT manual
for details)
on
Continuous
Critical error message. A serious error occurred in the instrument.
Instrument needs service before further using.
Wink Mode Green Red Green Red turn by turn
slow
wink
0.2 sec on
0.2 sec off
Wink mode
By a command send via FLOW-BUS the instrument can “wink” with Led’s to indicate its
position in a (large) system
normal
wink
1.0 sec on
1.0 sec off
Alarm indication: minimum alarm, limit/maximum alarm; power-up alarm or limit exceeded
or batch reached.
fast
wink
0.1 sec on
0.1 sec off
Switch-released, selected action started
- Instruction manual 1
- Disclaimer 2
- Symbols 2
- Warranty 2
- TABLE OF CONTENTS 3
- 1.1 INTRODUCTION 5
- 1.2 MULTIBUS TYPES 5
- 2 DIGITAL INSTRUMENT 7
- MEASURE 9
- CONTROL 9
- XdXcXbaY ⋅+⋅+⋅+= 10
- 2.5.1 General information 11
- 3.1 GENERAL 12
- 3.2 BRONKHORST SOFTWARE 12
- 3.3 PARAMETER USE 13
- Valve output 14
- Fluid name 14
- BRONKHORST® 15
- 4.1 MEASURE UNIPOLAIR 16
- 4.9 ANALOG INPUT 18
- 4.10 CONTROL MODE 18
- 4.11 SLAVE FACTOR 19
- 4.12 FLUID NUMBER 19
- APACITY UNIT INDEX 21
- APACITY UNIT 22
- 5 CONTROL PARAMETERS 23
- 1.05*response oldresponse New 24
- ALVE SAFE STATE 25
- 6 ALARM / STATUS PARAMETERS 26
- LARM DELAY TIME 28
- ESET ALARM ENABLE 28
- TATUS OUT POSITION 28
- SING AN ALARM (EXAMPLES) 29
- 7 COUNTER PARAMETERS 30
- 7.5 COUNTER LIMIT 31
- 7.6 COUNTER UNIT INDEX 31
- 7.8 RESET COUNTER ENABLE 32
- 8 IDENTIFICATION PARAMETERS 34
- DENTIFICATION NUMBER 35
- EVICE TYPE 35
- 9 SPECIAL PARAMETERS 36
- S1S2S3S4 37
- 10.1 ZEROING 39
- ESTORE PARAMETER SETTINGS 40
- 11.1 GENERAL 41
- 11.2 LED’S INDICATIONS 42
- Indication 43
- 11.3.1 General 45
- 11.4.1 Read control mode 48
- 11.4.2 Change control mode: 48
- 12 TESTING AND DIAGNOSTICS 49
- +31 573 45 88 39 50
Manuais e produtos relacionados com Hardware Bronkhorst Multibus
Hardware Bronkhorst Multibus Manual do Utilizador
(50 páginas)
(50 páginas)
(7 páginas)
Hardware Bronkhorst CEM W-300B Manual do Utilizador
(23 páginas)
(23 páginas)
Hardware Bronkhorst E-7000 Manual do Utilizador
(66 páginas)
(66 páginas)
Hardware Bronkhorst E-7000 Manual do Utilizador
(66 páginas)
(66 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.066 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais