
BRONKHORST®
Page 20 Operational instructions for digital multibus instruments 9.17.023
ALVE OUTPUT
This parameter is the signal coming out of the controller, going to the DAC for driving the valve. 0...16777215
corresponds with approximately 0...300mAdc. Maximum output voltage is the supply voltage and therefore in practice
300 mAdc may not be reached.
EMPERATURE
In MBC3 type of instruments the temperature surrounding the sensor is shown.
For (mini) CORI-FLOW type of instruments this parameter shows the temperature of the tubes.
It is not used in other instruments.
CTUAL DENSITY
-3.40282E+38 …
3.40282E+38
This parameter shows the Actual Density measured by the (mini) CORI-FLOW. It is not used in other instruments.
ENSOR TYPE
Unsigned char used to select proper set of units for certain sensor, together with Counter unit (MBC-II type).
Default setting is 3.
pressure (no counting allowed)
Controller
other sensor type (no counting allowed)
pressure (no counting allowed)
Sensor
other sensor type (no counting allowed)
APACITY
Capacity is the maximum value (span) at 100% for direct reading in readout units. The readout unit will be determined
by the capacity unit index / string. For each fluid (number) capacity will be stored separately.
This is the capacity zero point (offset) for direct reading in readout units. The readout unit will be determined by the
capacity unit index / string. For each fluid (number) capacity will be stored separately.
Comentários a estes Manuais